by Mike Masnick
Mon, Aug 6th 2007 8:18pm
It's no secret that many members of Congress seem to not understand technology issues, but they sure don't seem to like it when their own technology malfunctions. The Raw Feed points us to the news that the Congressional computer that shows vote tallies in the House of Representatives went on the fritz Friday afternoon, leaving those poor Congressional Representatives with no large monitor to tell them how their colleagues were voting. Apparently, without having this information being prominently displayed, some were concerned that they wouldn't know if their votes were being accurately counted (they were), and therefore began debating whether voting should cease until the computer was fixed. Rep. Joe Barton pointed out that each side had their own computers with tallies, and if those tallies matched up, it seemed silly to delay the voting, but eventually the Representatives decided it was just too difficult and recessed while the machines were fixed. What ever did they do before computers?
If you liked this post, you may also be interested in...
- House Intel Committee Says Snowden's Not A Whistleblower, 'Cause He Once Emailed His Boss's Boss
- This Bill Could Stop Protectionist State Broadband Laws, But ISP Control Over Congress Means It Won't Pass
- With Both Presidential Candidates Claiming To Be Against The TPP, President Obama Kicks Off Campaign To Ratify It
- Once Again, The Justice Department Fails To Tell Congress About Its Wiretapping Activities, As Required By Law
- Lobbyists Get Congress To Investigate P2P Software... Rather Than Bad Security And Employee Carelessness